Installation Type 1 - Directed DBALL2 Installation Manual

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready

Installation Type 1

Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety
CUT
Sentry Key
(+) Ignition:
Pink/White
or Pink/Gray,
pin 4
J1850:
White/Violet,
pin 2
6 1
Module-Sentry Key
Remote Entry
To vehicle's
(+) Parking Lights
Drivers Kick Panel
(+) Parking lights: White/Brown
or White/Orange ,pin 5
If grounded, the vehicle will NOT
[1]
All adapters are displayed from the wire side (unless specified otherwise).
4
J1850:
Ignition Interrupt ( vehicle side :
Ignition Interrupt ( conn. side : )
(+) Start er Output Yellow
(+) 12V Input:
( ) + 12 V (+) 12V Input:
(-) Ground:
(-) RAP Off Output:
(-) Parking Lights Output:
(+) Ignition Output
M UX Output
M UX Output
(+) Ignition: Pink/
White or Pink/
Gray, pin 3
(+) Start: Yellow , pin 4
5
Ignition Switch
(Black connector)
87
86 85
87a
30
+12V
Fuse 5A 1
remote start.
(RSR) Installation
devices, but
Violet/Yellow: 2
) Yellow: 8
Orange/Yellow: 9
: /Red : 11
Brown/Red: 12
Red: 13
Black: 14
Black/White: 1
Green/Black: 2
: Gray/Black: 7
: Violet/Green: 8
: Violet/Brown: 9
RF
Programming button
LED
M UX :
Violet/Brown, pin 2
(Black conn. third down from top)
26
1
34
are NOT supplied with the
Hood Pin
Remote Start Safety
Override Switch
6: White/Black:
DBALL
BCM
1
9
(-) Drivers Door Trigger:
Violet, pin 6
You can connect to either a
RFTD OR a SmartStart module.
Refer to the SmartStart/
Installation Notes for more information.
© 2017 Directed. All rights reserved.
Rev.: 20170817
Page 3
DBALL .
[1]
(-) Hood
XL 202
XL 202