Labomed eVO 300 User Manual page 10

SETUP (continued)
UNPACKING AND INSTALLATION (continued)
8. Attach the Fixation Light Wire from the Chin
Rest Assembly into the connector on the back
of the Power Supply Assembly. Refer to Figure-5.
9. Open the box with the Microscope Assembly.
Remove the Microscope Assembly, Slit lamp
Assembly, and Accessories. Refer to Figure-6.
10. Install the Slit Lamp Assembly onto the tracks of
the Table Top and slide the Guide Rail Covers
around the tracks. Refer to Figure-7.
11. Attach the Base Lamp Wire to the back of the
Power Supply Assembly. Refer to Figure-5.
12. Using the 4mm Hex Wrench, adjust the Patient
Handles by loosening the Allen Cap screws that
are securing them to the Chinrest Posts. Slide
the Patient Handles up or down to the desired
height, and secure them in place by tightening
the Allen Cap Screws. Refer to Figure-8.
10
8126200-795
Chin Rest
Wire
Figure-6 Microscope, Base, Accessories
Move
Handles Up
or Down
Figure -
eVO 300
Base Lamp
Wire
Figure-5 Connections
Slit Lamp
Accessories
Microscope
Slide
Figure-7 Install Base
Allen Cap
Screw
8 Adjusting Patient Handle Height
Issue 1.1
Printed on April,2016
eVO 300