Troubleshooting - Kalorik RVC 46111 Manual

• Carefully remove any debris wrapped between the main unit and the side
brushes.
• Use a cloth dampened with warm water to remove any dust from the
brushes or to gently reshape them.

TROUBLESHOOTING

Problem
The vacuum cannot
be activated.
The remote control
does not work.
vacuum
The stops
working suddenly.
Cleanings cannot
be scheduled.
Suction power is
weak.
The vacuum cannot
be charged.
The vacuum cannot
return to the
charging base.
www.KALORIK.com
Solution
Make sure the main power switch is in the "on" position.
Make sure the battery is fully charged.
Replace the batteries (2 AAA) in the remote control.
Make sure the remote control is within range (16 ft. /5 m) of the
vacuum
.
If you still have trouble, turn off the main power switch and
then turn it back on.
Replace the batteries in the remote control.
Make sure the vacuum is turned on and fully charged.
vacuum
Check if the
Check if the battery level is too low.
If you still have trouble, turn off the main power switch, wait for
2 seconds, and then turn it back on.
Make sure the main power switch on the bottom of the
vacuum is turned on.
Make sure the time, time of day (AM/PM), and the scheduled
time have been set correctly.
Check to see if the vacuum is sufficiently charged to start
cleaning.
Check if any obstructions are blocking the suction inlet.
Empty the dust container.
Clean the filters with a vacuum cleaner or a cleaning brush.
Check if the filters are wet due to water or other liquid on the
floor. Air-dry the filters completely before use.
Check if the indicator on the charging base lights up. If not,
contact the service center to repair or replace the charging
base.
Dust off the charging contact pins with a dry cloth.
Check if you can hear a beep when the vacuum is docked in
the charging base. If not, contact the service center to repair
or replace the charging base.
Remove objects within 3 ft. / 1 m to the left and right side and
within 6 ft. / 2 m of the front of the charging base.
When the vacuum is near the charging base, it will return more
quickly. However, if it is farther from the charging base, the
vacuum will need more time to return. Please be patient as it
works its way back.
is trapped or stuck on an obstacle.
14
RVC 46111 - 201010