Led Indicators - Kalorik RVC 46111 Manual

Automatic Cleaning
Press the "AUTO" button on the vacuum or press either the "AUTO" button on
the remote control to start cleaning in Auto Mode. The vacuum will start
cleaning on its own.
Manual Control
The vacuum can be controlled directly by using the directional buttons on the
remote control.
Power and Eco Modes
Pressing the "POWER" button changes between the two speed settings: Power
and Eco modes. The Power mode operates at a higher speed setting with
stronger suction power while the Eco mode operates at a lower speed, using
less energy. The speed setting can be changed during any of the other
operating functions.
Edge Setting
In Edge mode, the vacuum reduces its speed when it detects a wall and then
follows the wall to ensure the edge is cleaned thoroughly. The vacuum will
clean for 20 minutes and return to the charging base. To activate, press the
"EDGE" button on the remote control.
NOTE: Pressing the "POWER" button changes between the speed settings.
Using the Ion Function
The vacuum comes with an Ionic Air Purifier function that can be activated
when desired. By default, this function is enabled when first powering on the
product, indicated by the purple light around the AUTO button on top of the
unit. This function can be turned on or off by pressing and holding the AUTO
button on the remote control for approximately 3 seconds.

LED INDICATORS

Color
Permanently blue
Flashing blue
Light off
Permanently red
Permanently purple
www.KALORIK.com
Status
The battery is fully charged
The battery is charging
The vacuum is switched off
The floor brush is obstructed
The ion function is on
11
RVC 46111 - 201010