H3C SecPath M9000 Quick Manual page 3

Manual version: APW100-20200316
Figure 2 Aligning and inserting the module into the slot
5. Close the ejector levers. Make sure the module is in close contact with the backplane.
Figure 3 Closing the ejector levers
6. Use a Phillips screwdriver to fasten the captive screws on the module.
Removing the module
5.2
1. Use a Phillips screwdriver to loosen the captive screws on the module until all pressure is
released.
2. Simultaneously open the ejector levers on the module to separate the module from the
backplane, and then pull the module slowly out of the chassis along the guide rails.
iii
BOM: 3123A1Y9