Precor AMT12 Base Service Manual page 188

3 Slide the right side belt clamp off the cam towards the right, thread the clamp under the cam and
out to the left side of the AMT.
4 Slide the left side belt clamp off the cam towards the right and remove.
Gas Spring Removal
5 Release tension from the top of the gas spring by pushing a # 1 flat top screw driver in the slot under
the tension clip. Do not completely remove the retaining clip as it is difficult to reinstall.
Tip: If the lift motor is jammed at full elevation, remove the lower retaining clip to facilitate the gas
spring removal.
6 Using another flat head screw driver as a pry bar, place the screw driver head between the frame
and the top of the gas spring and pry the shock off the upper mounting stud.
7 Rotate the gas spring down and out of the way of the lift motor.
© 2012 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 188 of 214