Angelcare AC327 User Manual page 12

NO SOUND IS BEING TRANSMITTED
• Check the volume level on the Parent Unit and the Nursery Unit to ensure they are set to an appropriate level.
• Try bringing the Parent Unit closer to the Nursery Unit to see if you get sound.
• Charge the Parent Unit.
WEAK RECEPTION
• Bring units closer together.
• Change the position of one or both units.
• Place units on a flat surface away from baby's reach.
• Recharge the Parent Unit.
STATIC, DISTORTION, INTERFERENCES (FROM OTHER MONITORS, WIRELESS PHONES,
WALKIE-TALKIES, ETC.)
• Rotate Parent Unit or move it away from source of interference.
FEEDBACK (LOUD NOISES EMITTED FROM THE PARENT UNIT)
• Move units further apart (at least 3 metres).
• Decrease volume on Parent Unit.
THE PARENT UNIT SCREEN IS BLACK (PARENT UNIT IS OFF)
• Turn the Parent Unit back ON by pushing and holding the POWER ON/OFF button for 2 seconds.
• Recharge the Parent Unit.
MOVEMENT SENSOR PAD - NO ALARM
• Sources of vibration & movement, other than your baby's, can be detected by the Sensor Pad and the alarm will not
sound.
• Refer to Warnings 3 to 11 and see STEP 4, TEST THE SENSOR PAD.
MOVEMENT SENSOR PAD - FALSE ALARMS
• Replace the Sensor Pad battery CR2450.
• Turn OFF the Nursery Unit.
• Sensor Pad False alarms may happen for several reasons, always be sure to immediately check on baby whenever
an alarm sounds:
- Nursery Unit has not been turned OFF after you have removed your baby from the cot.
- Make sure there is no bedding between the mattress and the Sensor Pad.
- Sensor Pad has not been placed under the mattress properly. Be sure the Sensor Pad is on a flat, firm surface
with the printed side facing up.
- The sensitivity level may also need to be adjusted.
• Refer to Warnings 3 to 11 and see STEP 4, TEST THE SENSOR PAD.
NO SOUND IS BEING TRANSMITTED:
• Check that both units are powered ON.
• Check that Parent Unit is not on MUTE.
HOW TO CHECK THE PARENT UNIT BATTERY:
• Unplug the adaptor from the Parent Unit and check the battery level indicator.
12