Cuff Connection; Setting The Time And Date; Carrying Out A Measurement; Before The Measurement - Microlife BP 3BTO-AP Instruction Manual

Table of Contents

Available languages

4.3. Cuff connection

Insert the cuff tube into the opening provided on the left

side of the instrument, as shown in the diagram.

This blood pressure monitor automatically records the time and date of each measurement. This is very

important information as blood pressure normally varies over the course of a day.

1. After new batteries have been inserted the year is blinking in the display. You can adjust the year by

pressing the «M» button. Press the Time button to confirm and switch to month setting.

2. The correct month can be entered by the «M» button. Press the Time button to confirm and switch to

day setting.

3. Please follow the instructions above to set the day, hour and minutes.

4. Once the minutes have been set and the Time button is pressed, the date and time will be displayed on

the screen.

5. If you want to change the date and time again, please hold the Time button down for about 3 seconds

until the year number starts to flash. Now you can enter the new values as described above.

• Avoid eating, smoking as well as all forms of exertion directly before measurement. All these factors

influence the measurement result. Try to find time to relax by sitting in an armchair in a quiet

atmosphere for about 5 minutes before measurement.

• Remove any garment that fits closely to your upper arm.

• Always measure on the same arm (normally left).

• Take measurements regularly at the same time of day, since blood-pressure changes during the course

of the day.

Note: Comparable blood-pressure measurements always require the same conditions! These are normally

always quiet conditions.

• All efforts by the patient to support their arm can increase blood-pressure. Make sure you are in a

comfortable, relaxed position and do not activate any of the muscles in the measurement arm during

Table of Contents

Table of Contents