Example Of Establishing Communication To Plc: Controllogix Unit - EASTERN INSTRUMENTS CENTRIFEEDER ELECTRONICS Manual

Set Comm Format to "Data‐Real"
The IP Address is the address of the HMI.
This must be the same as the address set in
the HMI.
The diagram above is a screen capture from RSLogix 5000 software. See Red Lion Technical
Note TNOI17 for a description of the ControlLogix configuration steps. Note that the Module
Properties as shown above and on page 3 of the technical note differ. Please set the Comm
Format to Data‐Real, Input Size to 10, and Output Size to 9, as shown above.
Set the Comm Format, IP Address, and Connection Parameters as shown in the diagram.
Configuration data is not supported by the HMI. However, enter 1 for the Configuration
Assembly Instance and 0 for the Configuration Size.
For more detailed instructions, please see Technical Note TNOI17 on our website.
416 Landmark Drive
Wilmington, NC 28412
Example of Establishing Communication
To PLC: ControlLogix Unit
www.easterninstruments.com
Input Assembly Instance must be set to 2.
Input Size must be set to 10.
Output Assembly Instance must be
set to 3.
Output Size must be set to 7.
41
Phone:(910) 392‐2490
Fax: (910) 392‐2123