Table of Contents
Advertisement
Step 6:
You
I/O.WEIGHT.SP page. The WEIGHT
TARGET Button is highlighted in
Yellow. You can change the Weight
Target by pressing the current
Weight Target value twice. The first
press will outline the value in black,
as shown. The second press will
bring up a numeric keypad and the
Target Weight can be changed. The
acceptable range for a Weight
Target is displayed at the bottom of
the WEIGHT TARGET Button.
Step 7:
Now return to the I/O.ALARM.SP
page by pressing the OK Button in
the upper right hand corner of the
screen. You must now choose
which type of Weight Output you
would like to utilize. Press the
WEIGHT OUTPUT Button for your
options. You should now be on the
I/O.WEIGHT.OUT page. More infor‐
mation on the two types of Weight
Output, Pulse and Latch, can be
found on the I/O.WEIGHT.OUT page
in the Screen Guide section of the
manual.
Step 8:
If a Pulsed Weight Output is chosen, you should enter a duration for the Pulsed
Alarm. This is accomplished by pressing the DURATION Button, double clicking on
the old duration value and entering your new duration value via the numeric
keypad as before and press the OK Button.
Step 9:
Return to the I/O.ALARM page by pressing the TO ALARM Button on the upper
right hand corner of the screen. You must now select your logic. Press the LOGIC
Button and select your logic. Details on the LOGIC Button can be found in the HMI
Screen Guide for the I/O ALARM PAGE.
Step 10: Return to the I/O.ALARM page once more. To turn the alarm on, press the ENABLE
Button until "YES" is displayed in the blue display box to the right of the ENABLE
Button.
416 Landmark Drive
Wilmington, NC 28412
should
now
see
www.easterninstruments.com
the
32
Phone:(910) 392‐2490
Fax: (910) 392‐2123
Advertisement
Table of Contents
