Remote Ethernet Access Capabilities
The preferred method for transferring data from the Compact Flash card is to link the Digital
Electronics to a PC or Laptop using an Ethernet Cable. The main advantage of the remote
viewing capability is that run histories can be viewed and saved from the Electronics itself to a
hard drive or other desired external storage device.
Establishing Communication
The IP address and Subnet Mask for the Digital Electronics has been factory set as:
IP Address:
Mask:
NOTE: IF YOUR CENTRIFEEDER™ WAS SUPPLIED AS PART OF A LARGER SYSTEM OR MULTIPLE
UNIT SYSTEM, THE IP ADDRESS MAY BE DIFFERENT THAN SHOWN ABOVE.
In order to enable communication, the Local Area Connection Properties of the PC/Laptop
must be set appropriately.
*Please read the following if you are using Internet Explorer as your Internet Browser.
Make sure that in your Advanced Internet Options Menu, under Tools, under the Phishing
Filter option, that the "Automatic Website Checking" is off.*
Once TCP/IP settings are complete and the Ethernet Cable linkage is made, your Internet
Browser can be used to access the Digital Electronics by entering the IP address into the Ad‐
dress Bar. When entering the IP address please enter in the format illustrated below:
http://###.###.#.###
416 Landmark Drive
Wilmington, NC 28412
Digital Electronics connected via Ethernet Cable to a Laptop
Note: Crossover cable may be required for communication
directly between HMI and a computer
192.168.2.90
255.255.255.0
www.easterninstruments.com
36
Phone:(910) 392‐2490
Fax: (910) 392‐2123