Table of Contents
Advertisement
Wiring The Remote Electronics Cable At The Meter Module
REMOTE ELECTRONICS CABLE
The Remote Electronics Cable is a 9 conductor cable with a shield that attaches the Centri‐
Flow® Meter Module of your CentriFeeder to the Electronics Enclosure. It sends the measure‐
ment signal from the Transducer inside the Module to the Electronics Panel inside the Elec‐
tronics Enclosure. The standard length is 10' long, but it should be cut to the exact length
needed. If the distance from the CentriFlow® Meter Module to the Electronics Enclosure is
more than 10', a custom length cable which may be supplied with the meter, should also be
cut to fit. Excess cable should never be coiled up and placed into the CentriFlow® Meter Mod‐
ule. One end of the Remote Electronics Cable will be affixed to the meter module, while the
other end will be cut to length and will be wired to the Electronics Enclosure as demonstrated
in the "Wiring the Digital Electronics" portion of this manual.
PLEASE NOTE: The Electronics Cable MUST be run through grounded metallic conduit. If your
Electronics Cable has an Amphenol Connector on one end, we would recommend leaving a
short length of cable out of the conduit near the meter module and using a cable gland/wire
grip type of connector on the end of the conduit. The Amphenol connector can be exposed
without being inside the conduit.
WIRING THE METER MODULE ‐ 9 CONDUCTOR CABLE:
One end of the Remote Electronics Cable will be affixed with a 10‐pin Amphenol Connector.
This end will be connected to the Meter Module Casing as shown in the picture below. The
other end of the cable will be cut to length and will be wired to the Electronics Enclosure as
demonstrated in the "Wiring the Digital Electronics" portion of this manual.
PLEASE NOTE: VibraWeigh Amphenol Connector is
a 3‐pin connector while the Remote Electronics
Cable is a 10‐pin Amphenol Connector
Cable Gland
Connector
Amphenol Connector
Remote Electronics Cable
Amphenol
Connector for
VibraWeigh
Metallic Conduit
www.easterninstruments.com
Phone:(910) 392‐2490
416 Landmark Drive
12
Advertisement
Table of Contents
