To successfully utilize the alarm function of your Digital Electronics Package, please make sure
that the alarm relay is wired according to the diagram in the Wiring Customer Connections‐
Alarm Outputs section in Chapter 1 of this manual. The relay can be used to trigger alarms
which will either hold for a period of time after a set Total has been reached, or will latch
indefinitely until the Total is reset. Below is a step by step procedure for setting a Totalization
Alarm.
Step 1: From the TOP.I/O page press the
ALARM Button. Details of this page
can be found in the HMI Screen
Guide in this manual.
Step 2: You will now be on the I/O.ALARM
page. Details of this page can be
found in the HMI Screen Guide in
this manual.
Step 3: Press the TYPE Button. Select
'WEIGHT' from the pop up menu.
Check the Blue display box to the
right of the T YPE Button to make
sure that "Weight" is displayed.
Step 4: You have chosen to set the alarm
based on Weight, or Totalization.
Now you must select a target value
that will trigger the alarm. Select a
Target Value by first pressing the
TARGET Button.
Step 5: You should now be on the
I/O.ALARM.SP page. Press the
WEIGHT TARGET Button. Details of
this page can be found in the HMI
Screen Guide in this manual.
416 Landmark Drive
Wilmington, NC 28412
Setting the Alarm ‐ Totalization
www.easterninstruments.com
31
Phone:(910) 392‐2490
Fax: (910) 392‐2123