Table of Contents
Advertisement
Troubleshooting
Control Always in Audit Display Mode (Vend Models)
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Coin models: Is coin
No
vault switch being
pressed in?
Yes
(D)
Is J19 plug fully
No
inserted and in good
condition?
Yes
(C)
Is there 5VDC when
Yes
measuring between
H11-1 & H11-3 on AP2?
No
(C)
If there is less than
1VDC between H11-1 &
H11-3 on AP2 and you
still can't exit
Audit Display Mode
replace AP2 Control
Logic Board.
118
Ensure that your coin
box is pressing coin
vault switch. If coin
box is too short,
either install longer
box, or manually
depress switch.
Repair/ replace J19
plug as necessary.
Coin vault audit
switch circuit is
open, check switch
and wiring.
Part No. F8677701EN
Advertisement
Table of Contents
