Power Sensor Tab - R&S ZNA26 User Manual

®
R&S ZNA

5.2.10 Power Sensor tab

Allows you to set up and perform measurements using external power sensors.
The standard test setup for a "Power Sensor" measurement involves one analyzer
source port and a power sensor. The power sensor is connected to the VNA (e.g. to
the analyzer's USB port) and provides scalar wave quantity results. See
ter 4.7.38, "External power
Pmtr<i>
After a was connected, configured, and selected, you can use this button to create a
power meter trace in one of the available diagrams or in a new one.
Remote command:
CALCulate<Ch>:PARameter:MEASure
CALCulate<Ch>:PARameter:SDEFine
Power Meter
Shows a list of all power meters that have been properly configured. See
Devices"
The bordered label below displays the type and serial number of the selected power
meter.
Remote command:
CALCulate<Ch>:PARameter:MEASure
CALCulate<Ch>:PARameter:SDEFine
Auto Zero
Initiates an automatic zeroing procedure of the selected power meter.
The power meter must be disconnected from the RF power; see
"Zeroing",
Remote command:
SYSTem:COMMunicate:RDEVice:PMETer<Pmtr>:AZERo
User Manual 1178.6462.02 ─ 20
meters",
on page 819.
on page 287. A message indicates that zeroing is finished.
on page 285.
'TraceName', 'PmtrD1 | ...
'TraceName', 'PmtrD1 | ...
'TraceName', 'PmtrD1 | ...
'TraceName', 'PmtrD1 | ...
GUI reference
Meas softtool
Chap-
"Configured
Chapter 4.7.38.1,
350