Power Sensor Tab - R&S ZNC Series User Manual

®
R&S ZNC/ZND

6.2.8 Power Sensor Tab

Allows you to set up and perform measurements using external power sensors.
left = R&S ZNC or bidirectional R&S ZND
right = unidirectional R&S ZND
The standard test setup for a "Power Sensor" measurement involves one analyzer
source port and a power sensor. The power sensor is connected to the VNA (e.g. to
the analyzer's USB port) and provides scalar wave quantity results. See
ter 5.7.12, "External Power
Power Meter
Shows a list of all power meters that have been properly configured. See
Devices"
The bordered label below displays the type and serial number of the selected power
meter.
Remote command:
CALCulate<Ch>:PARameter:MEASure'TraceName', 'PmtrD1 | ...
CALCulate<Ch>:PARameter:SDEFine
Auto Zero
Initiates an automatic zeroing procedure of the power meter which must be disconnec-
ted from the RF power; see
is finished.
Remote command:
SYSTem:COMMunicate:RDEVice:PMETer<Pmtr>:AZERo
Source Port
Selects one of the available test ports of the analyzer as a source of the stimulus sig-
nal.
User Manual 1173.9557.02 ─ 37
Meters",
on page 459.
"Zeroing"
on page 183.
'TraceName', 'PmtrD1 | ...
on page 184. A message indicates that zeroing
GUI Reference
Meas Softtool
Chap-
"Configured
210