Preface Thank you very much for buying the BBF2004 series product. T h i s p r o d u c t i s a d e v i c e t h a t a s s i s t s i n d e v e l o p i n g s y s t e m s b y u s i n g M C U o f t h e 3 2 - b i t microcontroller, FR Family of Fujitsu Microelectronics Limited.
Operation mode specification pins, MD2, MD1 and MD0 to the operation mode of the MCU to be used. For details on setting pins MD2, MD1 and MD0, refer to "Usage of this Board " in Item 4 in "CPU Evaluation Board Instruction manual BBF2004 SERIES." For details on the operation mode, contact Fujitsu Microelectronics Limited.
YDC. Be careful not to connect PC writer, USB writer and PC writer at the same time. For information about the PC writer and USB writer, contact Fujitsu Microelectronics Limited. For information about the YDC writer, contact Yokogawa Digital Computer Corporation.
(2) Setting for daughter board Set No. 7 and No. 8 of DIP Switch "SW3" on the main board. [When PC writer is used] Set No.7 and No.8 of DIP Switch "SW3" to 'ON'. (Figure 3-3) P-SIN Y-SIN Y-SOT P-SOT [When USB/YDC writer is used] Set No.7 and No.8 of DIP Switch "SW3"...
4. DSU-FR EMULATOR This board is used with a FUJITSU MICROELECTRONICS DSU-FR EMULATOR MB2198-01-E (hereinafter called the emulator). 4.1 Setting for jumper pins When this board is used with the emulator, connect jumper pins to 1-2 of "JP1" to "JP5" on the daughter board with a jumper wire.
Connect jumper pins "JP6" to "JP13" on the daughter board with a jumper wire to be used. By connecting jumper pins "JP6" to "JP13" on the daughter board, MCU pins are connected to HDMI connector pins. Please refer to Table 5-2 below. Table 5-2 HDMI Connector(CN7) Jumper pins...
Support For the serial communication settings of this board and other technical inquiries, contact the company's Research and Development Div. 2004-FR120SQF-CB...