4. DSU-FR EMULATOR
This board is used with a FUJITSU MICROELECTRONICS DSU-FR EMULATOR MB2198-01-E
(hereinafter called the emulator).
4.1 Setting for jumper pins
When this board is used with the emulator, connect jumper pins to 1-2 of "JP1" to "JP5" on the
daughter board with a jumper wire. (Figure 4-1)
4.2 Connector for DSU-FR cable
Connect a DSU-FR cable MB2198-202-E to a connector "CN5" on the daughter board. (Figure 4-2)
5. HDMI
The daughter board has a HDMI connector (TYPE A) for HDMI CEC driver.
If you examine CEC driver, please connect an appropriate pull-up register to "JP9" (CEC-Line).
[Reference]
The daughter board is not designed for the examination of EDID and HPD.
If you examine EDID and HPD, please refer to Table 5-1 below.
Note: Parts for the Sink (TV) side and the Source (Player) side are different.
So, you should select the best parts for them to use.
Please confirm HDMI standards for correct information such as constants, circuit diagram, etc.
Table 5-1
R1
R2
R3
JP9 (CEC-Line)
JP10 (SCL-Line)
JP11 (SDA-Line)
1 2 3
1-2
JP1
JP2
JP3
JP4
JP5
Figure 4-1
MB2198-202
19
20
Connector for the MB2198-202
Figure 4-2
Sink (TV)
OPEN
1KΩ
OPEN
Pull-Up─(27KΩ)
Pull-Up─(47KΩ)
Pull-Up─(47KΩ)
2-3
CN5
1
2
Source (Player)
0Ω──(default)
OPEN ( default )
10MΩ─(─default─)
Pull-Up─(27KΩ)
Pull-Up─(1.5KΩ)
Pull-Up─(1.5KΩ)
13
2004-FR120SQF-CB