Using The Surface Elements - GASLAND chef Pro Series Installation Instruction

Using the surface elements.

Throughout this manual, features and appearance may vary from your model.
How to Set
Push the knob down and turn in either direction to the setting you want. When the
control is in any position other than Off , it may be rotated without pushing it down.
At Off, Hi and Simmer , the control clicks into position. You may hear slight
clicking sounds during cooking, indicating the control is keeping the power level
you set.
The controls for the radiant surface elements can be set anywhere between
Simmer and Hi for an unlimited number of heat settings.
With the infinite switch, the element cycles on and off to maintain your selected
control setting.
The On indicator light will glow when any surface element is on.
A Hot Surface indicator light will glow when any radiant element is turned on and
will remain on until the surface is cooled to approximately 150°F(65°C).
Note:
• It comes on when the element is hot to the touch.
• It stays on even after the element is turned off.
• It glows brightly until the element is cooled to approximately 150°F(65°C).
• Be sure you turn the control knob to Off when you finish cooking.
About the radiant surface elements...
The radiant cooktop features heating elements beneath a smooth glass surface.
Note:
A slight odor is normal when a new cooktop is used for the first time. It is
caused by the heating of new parts and insulating materials and will disappear in
a short time.
1 (844) 538-7890
support@gaslandchef.com
www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418
05