Installation Instructions; Before You Begin - GE Zoneline AZ75E09DAC Owner's Manual And Installation Instructions

Vertical air conditioners, cool only, heat/cool and heat pump models
Hide thumbs Also See for Zoneline AZ75E09DAC:
Table of Contents

Advertisement

Available languages

Available languages

Installation
Instructions
Questions? Visit our Website at: ge.com

BEFORE YOU BEGIN

Read these instructions completely and carefully.
IMPORTANT –
for local inspector's use.
IMPORTANT –
codes and ordinances.
Note to Installer –
instructions with the owner.
Note to Owner –
for future reference.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• You MUST use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner.
TOOLS YOU WILL NEED
Phillips screwdriver
Saw
Tape measure
WARNING:
installation, switch power off at the service panel
and lock the area to prevent power from being
switched on accidentally. When the area cannot
be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
Save these instructions
Observe all governing
Be sure to leave these
Keep these instructions
Adjustable wrench
Hammer
Before beginning the
Conditioners
or call 800.GE.CARES (800.432.2737).
IMPORTANT ELECTRICAL
SAFETY–READ CAREFULLY
CAUTION:
• All electrical connections and wiring MUST
be installed by a qualified electrician.
• Follow the National Electrical Code (NEC)
and/or local codes and ordinances.
• For personal safety, this Zoneline unit and case
must be properly grounded.
• Protective devices (fuses or circuit breakers)
acceptable for Zoneline installations are specified
on the nameplate of each unit.
• Do not use an extension cord with this unit.
• Aluminum building wiring may present special
problems—consult a qualified electrician.
• When the unit is not running there is still voltage
to the electrical controls.
• Disconnect the power to the unit before
servicing by:
1. Removing the power cord (if it has one) from
the wall receptacle.
OR
2. Removing the branch circuit fuses or turning
the circuit breakers off at the panel.
10
Zoneline Air

Advertisement

Table of Contents
loading

Table of Contents