Maintenance And Care; Accessories (Optional) - STEINEL Professional Series Instructions Manual

Twilight setting / response threshold
(Fig. 6.1 / L)
The floodlight's chosen response threshold can be
infinitely varied from approx. 2-1000 lux.
– Control dial set to
(depending on ambient brightness)
– Control dial set to
Manual override function (Fig. 6.2)
If a mains switch is installed in the mains supply
lead, the following functions are provided in
addition to simply switching light ON and OFF:
Sensor mode: (Fig. 6.2)
– Switch light ON (when light is OFF):
– Switch OFF and ON 2×. Light stays ON for
the period selected.
– Switch light OFF (when light is ON):
– Switch OFF and ON once. Light goes out or
switches to sensor mode.
Manual override: (Fig. 6.2)
– Activate manual override:
– Turn switch OFF and ON 4×. The floodlight is set
to manual override for 4 hours (status LED ON).
Then it returns automatically to sensor mode
(status LED OFF).
– Deactivate manual override:
– Switch OFF and ON once. The floodlight goes
out or switches to sensor mode.
Important:
Switching must take place within 0.2 to 1 second.
Reach adjustment
Depending on mounting height, the detection zone
setting can be optimised to suit requirements. The
film shroud can be used for masking out any num-
ber of lens segments to limit reach as required.
Inadvertent triggering is ruled out or the sensor can
be targeted to watch over danger spots.
– limited at side (Fig. 6.3)
– limiting reach (Fig. 6.4)
Other:
– Floodlight adjustment range (Fig. 6.5 / 6.6)

7. Accessories (optional)

Remote control RC 9 (EAN 4007841007638)
The XLED PRO XL S provides additional functions
by using the RC 9 remote control. The optional
RC 9 remote control makes it easier to install
= daylight mode
= twilight mode (approx.
2 lux)
larger-type lighting systems as it is then no longer
necessary to set each light before it is installed.
Any number of floodlights can be controlled via
remote control.
Remote control functions
1. Brightness setting
2. Daylight mode
3. Night mode
4. Teach mode
5. Time setting
6. Any chosen light ON time
7. Manual override
8. Install mode
9. Reset
Smart remote (optional)
(EAN 4007841009151)
– Control via smartphone or tablet
– Replaces remote control
– Load appropriate app and connect by Bluetooth

8. Maintenance and care

This product requires no maintenance.
The detector lens may be cleaned with a damp
cloth (without detergents) if dirty.
Important note: the control gear cannot be
replaced.
9. Disposal
Electrical and electronic equipment, accessories
and packaging must be recycled in an environ-
mentally compatible manner.
Do not dispose of electrical and electronic
equipment as domestic waste.
EU countries only:
Under the current European Directive on Waste
Electrical and Electronic Equipment and its imple-
mentation in national law, electrical and electronic
equipment no longer suitable for use must be
collected separately and recycled in an environ-
mentally compatible manner.
– 15 –