HEADLIGHT BEAM ADJUSTMENT
A
Switch A is used to adjust the height of
the headlight beams according to the
load.
With the dipped beam headlights lit,
press or lift switch A as many times as
is necessary to select the required po-
sition on the instrument panel.
Note: depending on the vehicle, when
the engine is started, the position se-
lected is displayed on the instrument
panel for approximately 30 seconds
and for 5 seconds each time switch A
is pressed.
(1/2)
Driver alone or with front
passenger
All seats occupied
Driver with passengers and
luggage (or load) reaching the
maximum permissible all-up
weight
Driver without passengers and
luggage (or load) reaching the
maximum permissible all-up
weight
The table below gives some examples. In all cases, adjust control A according to
the vehicle load so that the road can be seen and other drivers are not dazzled.
Examples of positions for adjusting
control A according to the load
Van version
Estate versions
0
-
-
4
0
1
2
3
1.135