Install the Card
I I n n s s t t a a l l l l t t h h e e C C a a r r d d
NOTE
NOTE
To install the PXGMS card:
1.
On the PXGMS card, verify that all six DIP switches are in the OFF position (see
Figure 1. Verify DIP Switches are OFF
2.
If not already done, record the MAC address from either the shipping box label or the label on this card for
future reference (see the
3.
Remove the mini-slot cover from the UPS. Retain the screws.
NOTE
4.
To prevent electrostatic discharge (ESD), place one hand on a metal surface, such as the UPS rear panel.
5.
Slide the card into the open slot and secure it with the screws removed in
2
Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
The hot-swappable PXGMS card can be installed without turning off the UPS or
disconnecting the load.
If your UPS is a 93PM, there may be a metal strip that prevents you from installing the
PXGMS card. If so, locate the metal strip bolted to the top of the UPS. Remove the
three bolts that attach the metal strip. Then, follow the procedure to install the PXGMS
card.
Installation Checklist
If another card is already installed with an attached communication cable, disconnect the
cable and then remove the card.
section).
Figure
1).
Step 3
(see
Figure
2).