SMART 6000S Series User Manual page 50

Chapter 4
Connecting computers and other devices
NOTES
Install SMART software on computers you connect to the display (see Installing and using SMART
l
software on page 46).
Your organization's installers might have connected cables to the display and run the cables behind a
l
wall or under the floor to a desk or table where you can place your computer.
You can charge devices connected to the USB Type-C receptacles. SMART Board 6000S (V3)
l
models can provide up to 65 W to connected devices (the USB Type-C receptacle labeled USB-C 2
on the rear connector panel provides 30 W when an OPS PC module is installed). The USB Type-C
receptacle on SMART Board 6000S (C) models can provide up to 60 W.
Viewing a connected computer's input
Use the Input app to view a connected computer's input on the display.
To view a connected computer's input
1. Connect the computer to the display.
2. Do one of the following:
If iQ is enabled
Tap Input on the Home screen.
OR
Press Input on the remote control.
The display shows thumbnails of the devices that are connected to the display:
A grey thumbnail indicates no device is connected to an input.
o
A black thumbnail indicates a device is connected to an input but is in Sleep mode.
o
A thumbnail showing a preview screen indicates an active device is connected to an input.
o
TIP
If iQ is disabled and you want a computer's input to appear whenever you wake up the display, tap
the star in the upper-left corner of the computer's thumbnail.
3. Tap the computer's thumbnail.
smarttech.com/kb/171415
If iQ is disabled
Press the Home button
on the remote control.
or the Input button
50