Control Box Installation; Speed Control Unit Installation; Components Of Belt Cover Adjustment - Siruba C007K Manual

Adjust on needle position
1. Takes off hand wheel of sewing machine.
2. Turns the shaft gets the scale stop at highest point
(or the point of up position in sewing machine).
3. Turn the encoder disc and the screw (A) to aim at
wire outlet of motor.
Remark: above description is a standard of
position adjustment, if the position
is not satisfy pleases adjust till it
match your requirement.

(2). Control Box Installation:

a). Leave 100 mm space at right

(3). Speed Control Unit Installation:

a). Speed Control Unit
Screws
Always u
se screwdriver to tightly secure screws

(4). Components of Belt Cover Adjustment:

A. Finger Guard Adjustment : ( For CE type only )
1). Factory default, Finger guard is set at ( B ). (for lockstitch machine rotation direction)
2). When use Interlock stitch machine, Finger guard is set at (C).
Counterclockwise
10 mm
B
Front view
b). Mounting
Measurement:
100 mm
b). Keep rod in vertical, secure the unit under the table
Support stand
Pedal rod
C
A
i
70M under the working table
239mm
231.4mm
171mm
60mm
Table
Speed control
V-belt
Finger guard
Pulley
5
c). Installation layout
c).Installation layout
unit
Clockwise
C
B
Front view
P S A B C D
Control
box
P S A B C D
10 mm
A