Oil Inside Of The Face Cover; Removing And Replacing The Bulb - Siruba HSP-68100 Instructions Manual

Anchor screw
Oiling place
Oiling place
Oiling place

OIL INSIDE OF THE FACE COVER

Note: Pull stehts net-put for the machine if it out of
operation are, if the lamp replaced or if them
are cleaned.
.
Open the face cover with the screw driver and places
one drop of oil on moving points only.
REMOVING AND REPLACING THE
BULB
1. Remove the power supply plug and open the face
cover.
2. Wait bulb cools about 3~5 minutes.
3. Remove the bulb in downward directin as
illustrate. Fit a new one and push in upward
direction.
4. Use 12V ~ 5W bulb.
Note ： ： ： ： When loads the bulb, the light bulb two side has
pillar must put in bulb holder.
- 35 -