Bosch VideoJet 8008 Installation And Operating Manual page 89

VideoJet 8008 | Installation and Operating Manual
Network
The settings in this window are used to integrate the unit into an existing
network.
Warning!
Changes to the IP address, subnet mask or gateway address are
transferred to the unit by clicking Set. However, they only take effect after
the unit is restarted.
– Click Set after entering a new IP address.
– To do this, enter the old IP address followed by /reset (for instance
192.168.0.80/reset) in the address bar of your web browser. The
VideoJet 8008 will be restarted, after which it can only be accessed at the
new IP address.
IP address:
Enter the desired IP address for the VideoJet 8008 in this field. The IP address
must be valid for the network.
Subnet mask:
Enter the appropriate subnet mask for the set IP address here.
Gateway address:
If you want the unit to establish a connection to a remote location in a different
subnet, enter the IP address of the gateway here. Otherwise, this field can
remain empty (0.0.0.0).
Bosch Security Systems | 2005-06 | V2.0
EN | 89
Configuration using a Web Browser