Chapter 4 Installation - Bosch VideoJet 8008 Installation And Operating Manual

VideoJet 8008 | Installation and Operating Manual
Installation
The VideoJet 8008 is designed as a table-top unit and for installation in control
cabinets. The assembly kit supplied allows it to be installed in a
19" rack quickly and easily.
For table-top operation, four self-adhesive, anti-slip rubber feet are supplied,
which can be stuck under the unit.
Warning!
The unit is intended for use indoors. Select a suitable location for
installation where the unit will not be subjected to conditions of extreme
temperature or humidity. The ambient temperature must be within the
specifications for the unit in use (see page 128), and the relative humidity
may not exceed 80% (non precipitating).
The unit generates heat during operation. Ensure that there is adequate
ventilation and also that there is enough clearance between the unit and
heat-sensitive objects or equipment.
Please ensure the following conditions for installation:
Do not install the unit close to heaters or other heat sources. Avoid locations
in direct sunlight.
Allow sufficient space for running cables.
Ensure that the unit has adequate ventilation. For control cabinet installation
of multiple units, pay particular attention to the overall thermal load.
Use only the cables supplied for connections or appropriate cables resistant
to electromagnetic interference.
Position and run all cables so that they are protected from damage, and
provide strain relief where needed.
Avoid shocks, bashes and strong vibrations as they might destroy the unit.
Bosch Security Systems | 2005-06 | V2.0
EN | 17
4
Installation