Table of Contents
Advertisement
Setting up the lawnmower
4.
Testing the Start points
Through this testing, you can check the start points which you added in [3.Mowing start points].
NOTE:
- Perform each test when the lawnmower is connected to the docking station.
Select [4.Test start points] and press the
1
4-
button to check the start points.
Select a start point number and press the H button.
2
4-
The information of the selected start point is displayed.
Confirm the setting information of the selected start
3
4-
points.
Close the control panel cover.
4
4-
The lawnmower starts towards the selected start point.
When the test is correctly finished, the lawnmower rolls
slowly from the minimum to the maximum exit angle,
and a beep sound is emitted from the lawnmower.
Press the manual STOP button.
5
4-
The control panel cover pops up.
The message "Do you want to modify the start point?"
appears on the display.
Select [Yes] or [No] to the question of the test result
6
4-
and press H button.
If you select [Yes], the Mowing start points screen is
displayed to configure the start point settings.
If you select [No], go to step 4-7.
NOTE:
- For details on the start point settings, see step 3-3
of "3. Setting the mowing start points" (M page 23).
24
Setup wi z ard
H
1.C utti ng hei ght
2.G ar den l ayout
3.M owi ng s tar t poi nts
4.Tes t s tar t poi nts
5.Wor k t im er
Test st art point s
Poi nt
/
1
/
2
/
3
/
4
/
5
/
0
H o m e
Test star t poi nts
Point 1
Loc ati on
Pas s age wi dth
Dock the mower
in the station
Test star t poi nts
Do y ou want to m odi fy the
s tart poi nt?
Yes
4/5
4/5
0
5 0 m
0
m
0
m
0
m
0
m
NEXT
4/5
CW 50m
2
4/5
No
Advertisement
Table of Contents
