Table of Contents
Advertisement
Setting up the lawnmower
2.
Setting the garden layout
Through this setting, you can configure the information of your garden layout for operating the lawnmower.
[2.Garden layout] is selected. Press the H button to
1
2-
configure the garden layout.
Garden layout screen is displayed.
Select an installation pattern for the docking
2
2-
station, and press the H button.
Refer to page 12, to confirm which pattern matches your
actual installation.
Enter the values of the boundary wire length and
3
2-
garden size.
NOTE:
- For details on the boundary wire length or
garden size, contact your dealer.
- Input the boundary wire length exactly because
the values which are automatically configured
are associated with the boundary wire length.
Select [NEXT] and press the H button.
4
2-
Select [Yes] or [No] to the question on the narrow
5
2-
passages, and press the H button.
Narrow passages have a passage width of 3.0 m or
less.
[YES] → Go to Step 2-6
[NO] → Go to "3.Setting the mowing start points"
(M page 23)
Check that the value is selected and press the H
6
2-
button, use the number buttons to input a value
from 1.0 to 3.0 m.
When you are finished inputting a value, press the
7
2-
H button. [NEXT] will be selected. Press the H
button again.
The configuration of garden layout is completed.
The setup wizard top screen is displayed and [2.Garden
layout] is checked.
22
Setup wi z ard
1.C utti ng hei ght
2.G arden lay out
3.M owi ng s tar t poi nts
4.Tes t s tart poi nts
5.Work t im er
Gar den l ay out
Docking direction
Gar den l ay out
Boundary wire length
500m
(50 – 1 000m)
Gar den s i ze
2
2500m
( 100 – 40 00m
Gar den l ay out
Are there
narrow passages?
(1. 0 – 3.0m )
Yes
Gar den l ay out
What is the minimum
passage width
(wi r e to wi r e)
(wi r e to obs tr acl e)
1.0m
(1.0 – 3.0m )
2/5
2/5
2/5
2
)
NEXT
2/5
No
2/5
NEXT
Advertisement
Table of Contents
