Pre-Defi Ned Parameter Sets - FAAC B680H Manual

Hide thumbs Also See for B680H:

Table of Contents

Loop 1 articulated lorry function

This function lets you increase the level of sensitivity at the time of detection, to allow correct

detection even in case of very tall vehicles or during the transit of a tractor and trailer.

enabled

disabled

Loop 2 articulated lorry function

This function lets you increase the level of sensitivity at the time of detection, to allow correct

detection even in case of very tall vehicles or during the transit of a tractor and trailer.

enabled

disabled

Work time (time-out)

Maximum work time of the automated system before the motor stops, if the open or close position

is not reached. The value can be set from

changes to minutes and tenths of a second (separated by a decimal point) and time is adjusted

in 10-second steps up to the maximum value of

Red light brightness (OUT 5)

Changing this value increases or decreases the output voltage for OUT 5, changing the bright-

ness of the rope light.

Green light brightness (OUT 6)

Changing this value increases or decreases the output voltage for OUT 5, changing the bright-

ness of the rope light.

STATUS OF THE AUTOMATED SYSTEM:

Exit from programming, storage of data and automated system status display.

6.3 Pre-Deﬁ ned Parameter Sets

The table below shows, for each set of pre-defined parameters, the

values that they will load in the board memory.

BASIC programming

B680H

sec. in one second steps. Next, the display

4.1

minutes.

ADVANCED programming

The following table shows, for each set of pre-defined parameters,

the values that they will load in the board memory, in ADVANCED

programming.

732719 - Rev.D

Table of Contents