Safety Instructions; Check Before Use - Kayoba 005025 Translation Of The Original Operating Instruction

EN

SAFETY INSTRUCTIONS

WARNING!
• A bike is exposed to wear, like all
mechanical equipment, when you use it.
Different materials and components
react in different ways to wear and
stress. If the life span of any part of the
bike (including the frame, forks and
components) has been exceeded there is
a risk of the part suddenly breaking, and
that you lose control and fall off. Cracks,
scratching or changes in colour in areas
exposed to high levels of stress indicate
that the component has reached the end
of its useful life and should be replaced.
• The electric bike is a vehicle.
– Always follow local traffic regulations.
Passengers are not allowed to ride
on the electric bike. Reduce your
speed and increase the distance to
other road users in rain, snow or
slippery conditions.
• You should not attempt to dismantle parts
from the bike for maintenance. Contact a
qualified service technician.
• Do not ride through pools of water or
other accumulations of water. Water can
penetrate into the hub motor and cause
short-circuiting and irreparable damage.
• The two metal connector plates on the
back of the battery box are the battery's
positive and negative terminals. Do not
touch the battery terminals, especially
with wet hands. Make sure that metal
objects do not come into contact with the
battery terminals as this can cause
short-circuiting and result in electric
shock, severe burn injuries and damage to
the battery.
• Never allow persons who are not familiar
with electric bikes, or who have not read
these instructions, to use this product.
• Do not make any modifications to the
product.
40

CHECK BEFORE USE

• The tyres are in good condition and have
the correct tyre pressure (3.5–5.3 kg).
• The battery is charged.
• The stem, handlebars and saddle post are
correctly fitted and tightened.
• The axle nuts are correctly tightened.
• The bell is working.
• The rims are in good condition and
undamaged. A worn rim is a safety risk
and should be replaced.
• Screw unions and components are properly
tightened and not worn or damaged.
• The seat is comfortably adjusted.
• The brakes are working properly.
• The steering does not jam, or has too
much play.
• The wheels are not warped and the wheel
bearings are correctly adjusted.
• The wheels are properly attached in the
back/front forks.
• The pedals fit properly in the crank arms.
• The gears are correctly adjusted.
• All the reflectors are fitted.
• After adjusting, check that all screw
unions are correctly tightened and that
the wires are undamaged and correctly
drawn along the frame.
• The maximum load including cyclist and
baggage is 130 kg.
• Use the brake handle on the left side of
the handlebars to brake the front wheel,
and use the brake handle on the right side
to brake the back wheel.
• The electric bike works reliably in all kinds
of weather, but the electrical components
and/or motor can be damaged during
prolonged or excessive exposure to water.
• Never touch the electrical components
with wet hands. Do not touch the positive
and negative terminals on the battery at
the same time – short circuiting and
personal injury.