Cleaning Foam And Pliable Plastics; Cleaning Contacts - Honeywell Vocollect A700 Series Product Manual

Cleaning Foam and Pliable Plastics

Clean headset foam parts (ear pads and headband pads) as well as flexible
bands and non-foam padding with a mild soap and water. Wash pads carefully
so as not to tear or detach them.
Air dry the parts. Use of a concentrated heat source such as a hairdryer or
clothes dryer is not recommended.
Replace pads that are excessively dirty, such as headset windscreens.

Cleaning Contacts

Clean flat contacts on the device, such as the Talkman Connector (TCO), or flat
contacts on the battery and charger with a 70% isopropyl alcohol solution.
Use a soft, lint-free cloth or premoistened alcohol wipe. Avoid using a cloth with
long or thick fibers as the fibers can attach to the connectors and cause
intermittent contact.
Remove corrosion with a soft eraser (for example, a pencil eraser). The eraser
must be in good condition (soft, pliable, and not worn down to the mounting). A
good test is to rub the eraser against your skin. If it feels abrasive, do not use it,
because it will damage the surface of the connectors.
You can also use a three-row cleaning brush with natural hog hair bristles to
gently brush away dirt on the contacts. A final alcohol wipe after this should
ensure a clean contact.
Never bend or manipulate battery contacts.
Contact an authorized Honeywell Service Center to repair or replace contacts
that are extremely corroded, bent, or missing.
31 A700x Product Guide