Cleaning Procedures For Honeywell Equipment; Cleaning Plastics; Cleaning Hard Plastics - Honeywell Vocollect A700 Series Product Manual

l
l
1. Using a standard USB cable, connect the device to a computer.
2. Power on the device.
3. On your computer, run a serial terminal emulator, such as HyperTerminal,
The device transfers platform logs 30 seconds after connection and then once a minute
after that. The results are viewable within the serial terminal emulator window.

Cleaning Procedures for Honeywell Equipment

Honeywell Solutions products have a long service life if they are maintained
properly. Follow recommended cleaning practices.
While Honeywell equipment is manufactured and tested to be resistant to
normal dirt and deposits from the workplace environment, the build-up of
residue can damage the equipment and degrade performance over time.
l
l
l

Cleaning Plastics

Cleaning Hard Plastics

Clean the hard plastics on headsets, devices, chargers, and batteries with a soft
cloth that is wet with a solution of 70% isopropyl alcohol and 30% water.
Use a soft brush to keep the pocket areas of chargers free of dust and debris
that may interfere with the seating of equipment or electrical contact.
A700x Product Guide
Installing the USB Driver on Windows 7 or Vista
Installing the USB Driver on Windows XP
using the following settings:
Bits per Second: 57600
l
Data Bits: 8
l
Parity: None
l
Stop Bits: 1
l
Flow Control: None
l
Dirt or corrosion can prevent the proper seating of terminals in chargers
and may cause intermittent charging.
Talkman® Connector (TCO) contacts that build up dirt, chemicals, and
corrosion may cause intermittent contact, static, and recognition problems.
Excessive dirt on a keypad membrane can cause the membrane to weaken
and tear.
CAUTION
Use only a solution of 70% isopropyl alcohol and water to clean
equipment. Other products have not been tested and may degrade the
equipment.
30