Honeywell Vocollect A700 Series Product Manual page 118

TIP
In order to use QTERM devices with a Thai TTS, you must use a QTERM-
G55 running device software version 3.1 or newer. After connecting the
QTERM, verify you have the correct software by checking debug logs for
the message "TRAIN DEVICE: Device query detected training device G55
using v3.1." If you do not see this message, you do not have the correct
software, and you must obtain it to use the device with a Thai TTS.
1. Be sure the training device is configured.
2. Connect the training device to your Talkman device.
3. Turn your Talkman device on by pressing the Play/Pause button.br />The
4. Say "Zero."
5. Say "One."
6. Say "Two."
The Talkman device stops speaking and words to train are only displayed on the
screen. Speak the words as they appear on the device display. Words appear in
random order and are repeated at least four times to get an accurate recording
of how you speak the words. If it prompts you for phrases, say the phrase
naturally, without exaggerated pauses between the words.
When the device has asked for all words in the task the necessary number of
times, the device will say, "Creating voice templates. Please wait." It will then
beep periodically until all of the remaining voice templates have been created.
During the beeping, the device periodically repeats the "... Please wait" phrase to
alert the user that it is still busy. When the remaining voice templates have been
created, the device says, "Finished creating voice templates." The device then
goes to sleep. You can begin the task by pressing the Play/Pause button.
You can expect the device to beep for approximately two minutes after all of the
vocabulary words have been spoken. If the operator presses any of the device's
buttons during this time period, the device says, "Creating voice templates.
Please wait."
A700x Product Guide
LED indicator turns red for a few moments then turns green. The training
device displays, "Please keep quiet for a few seconds."
NOTE
If your device does not say this, press the Operator button to
l
manually perform a background noise sample.
If you cannot see words displayed on the training device screen,
l
there may be a problem with the contrast on the device. Refer to the
manufacturer's documentation.
The Talkman device says and the training device displays, "Please say zero."
The Talkman device says and the training device displays, "One."
The Talkman device says and the training device displays, "Two."
The Talkman device says, "Please say the following words as they appear on
the screen."
110