Basic Settings; Table 9: Basic Settings; Figure 37: Basic Settings Page - Grandstream Networks GDS3710 User Manual

https://arttel.ru/

Basic Settings

This page allows users to set either a static or DHCP IP address to access the GDS3710.
IP Address Mode
IP Address
Subnet Mask
Gateway
DNS Address Type
DNS Server 1
DNS Server 2
Notes:
•
If the GDS3710 is behind SOHO (Small Office Home Office) router with port forwarding configured
for remote access, static IP should be used to avoid IP address changes after router reboot.
•
TCP port above 5000 is suggested to Port forward HTTP for remote access, due to some ISP would
block port 80 for inbound traffic. For example, change the default HTTP port from 80 to 8088, to
make sure the TCP port will not be blocked.
•
In addition to HTTP port, RTSP port is also required to configure via port forwarding, so that the
remote party can view the video stream.
•
If the default TCP port 80 is changed to port "A", then RTSP port should be "2000+A" (changed
from default TCP 554). Both TCP port "A" and "2000+A" should be configured for port forwarding
https://arttel.ru/shop/ip-domofony/grandstream-gds3710

Figure 37: Basic Settings Page

Table 9: Basic Settings

Choose DHCP or Static IP. Default DHCP. (Static recommended)
Enter the Static IP of the GDS3710.
Enter the Associated Subnet Mask.
Enter the Gateway IP address.
Choose DNS type: Dynamic DNS or Static DNS.
Fill in DNS Server 1 IP address.
Fill in DNS Server 2 IP address.
GDS3710 User Manual
P a g e | 48