Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec PGSS 10-20V
Summary of Contents for Trotec PGSS 10-20V
- Page 1 PGSS 10-20V ORIGINAL INSTRUCTIONS CORDLESS GRASS AND SHRUB SHEARS...
-
Page 2: Table Of Contents
This signal word indicates a hazard with a low risk level which, if not avoided, can result in minor or moderate injury. Note This signal word indicates important information (e.g. material damage), but does not indicate hazards. cordless grass and shrub shears PGSS 10-20V... -
Page 3: Safety
Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. cordless grass and shrub shears PGSS 10-20V... - Page 4 Power the battery and increase the risk of fire. tools are dangerous in the hands of untrained users. cordless grass and shrub shears PGSS 10-20V...
- Page 5 • Only use the device in sufficient daylight or with good shears reduces the risk of injury caused by the blade. artificial lighting. Lack of light or poor illumination of the working area can lead to accidents. cordless grass and shrub shears PGSS 10-20V...
- Page 6 The device is not only suitable for commercial use. and health of persons due to the shear blade's follow- up time. We recommend using the power tool with original Trotec accessories. Warning This symbol indicates that there is a danger to the life Foreseeable misuse and health of persons due to parts flung out.
- Page 7 There is a risk of a short-circuit due to liquids penetrating the housing! Do not immerse the device and the accessories in water. Make sure that no water or other liquids can enter the housing. cordless grass and shrub shears PGSS 10-20V...
- Page 8 Dangers can occur at the device when it is used by untrained people in an unprofessional or improper way! Observe the personnel qualifications! Warning The device is not a toy and does not belong in the hands of children. cordless grass and shrub shears PGSS 10-20V...
-
Page 9: Information About The Device
• 1 x Device PGSS 10-20V • 1 x grass shears attachment Device depiction • 1 x shrub shears attachment • 1 x protective cover for grass shears attachment • 1 x protective cover for shrub shears attachment • 1 x Manual cordless grass and shrub shears PGSS 10-20V... - Page 10 1.5 m/s² Sound values according to EN 62841 Sound pressure level L Shrub shears 63.2 dB (A) Grass shears 63.2 dB (A) Sound power L Shrub shears 83.2 dB (A) Grass shears 83.2 dB (A) Uncertainty K 3 dB cordless grass and shrub shears PGSS 10-20V...
-
Page 11: Transport And Storage
– Only ship batteries if their housing is undamaged. – Mask open terminals with tape and pack the battery in a way that it cannot move inside the packaging. – Please also observe any other national regulations. cordless grass and shrub shears PGSS 10-20V... -
Page 12: Start-Up
Inserting the battery LED in the battery level indication (11) is illuminated), the 1. Slide the battery (10) onto the device until it locks in place. battery should be charged. To do so, please proceed as follows: cordless grass and shrub shears PGSS 10-20V... - Page 13 3. Press the two release buttons (9) on both sides of the battery. shear attachment (4, 5) and remove the shear 1. Press on the battery icon (16) on the battery (10). attachment (4, 5). ð You can read the battery status from the battery level indication (11). cordless grass and shrub shears PGSS 10-20V...
-
Page 14: Operation
• Guide the device along the edge of the lawn. Avoid the cutting blade coming into contact with paved ground, stones or garden walls as this will significantly shorten the service life of the cutting blade. cordless grass and shrub shears PGSS 10-20V... - Page 15 2. Remove the protective cover (7, 6) from the shear attachment (4, 5). 3. Press the start lock (8) to be able to actuate the on/off switch (1). 4. Press the on/off switch (1) and hold it during operation. cordless grass and shrub shears PGSS 10-20V...
-
Page 16: Available Accessories
• Check the quick charger for damage. If the quick charger Using insertion tools or accessories other than those is damaged, stop using it. Contact the Trotec customer specified in the instructions may cause a risk of injury. service. -
Page 17: Maintenance
• Dry the device with a soft, lint-free cloth. • Dry the bits with a soft, lint-free cloth. • Keep the connecting terminals on the device and charger clean. cordless grass and shrub shears PGSS 10-20V... -
Page 18: Disposal
EC Machinery Directive 2006/42/EC, Annex II, Part 1, Section A Detlef von der Lieck, Managing Director We – Trotec GmbH – declare in sole responsibility that the product designated below was developed, constructed and produced in compliance with the requirements of the EC Machinery Directive in the version 2006/42/EC. - Page 19 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...