Table of Contents
Advertisement
Installation
For 6V batteries, connect the first and last batteries to connectors 1 and 8, respectively. (The
other connector positions are not important.)
24
Dress the cables close to the tops of the batteries, and secure with cable ties. Store any cable slack in the cable
aisle.
25
If the batteries were equipped with protective plastic covers (Step 2), locate and remove the thin-walled panel
at the center of the short side of the cover as shown in
it snaps off.
The battery cables (and TSU leads, if equipped) will be brought out from under the cover,
through the removed panel, to the cable aisle.
34
Battery drawer
String 1
BATT1
BATT4 BATT5
Figure 27. Battery Bus Connector Locations - 12V Batteries
Battery drawer
BATT1
Figure 28. Battery Bus Connector Locations - 6V Batteries
November 9, 2001
String 2
BATT8
Battery
connector bus
Battery
connector bus
BATT8
Figure 29 on page
LTPS-UM-8007-01, Issue 1
35. Using pliers, flex the panel until
SPX-CABFIN01, SPX-CABFIN04
Advertisement
Table of Contents
