Table of Contents
Advertisement
Installation
1
Remove the base cover plates below bay No. 1 and bay No. 2 (battery drawer covers) for access to the cabinet
base mounting holes.
The cabinet base mounting holes are located near the battery drawer two front corners, as
shown in
Figure 7 on page
Mounting
hole
2
Insert the cable sling securely through both eyebolts, as shown in
with the crane.
3
Attach a length of 5/8-inch diameter rope to a lifting eyebolt as a tagline.
4
Remove the four pallet mounting bolts securing the cabinet to the pallet.
5
Close and latch the cabinet doors.
6
Clean all debris from the cabinet foundation pad.
7
Dress the cables toward the end of the pad in preparation for placing the cabinet.
12
12, and two rear corners.
Figure 7. Cabinet Base Mounting Hole Locations
November 9, 2001
LTPS-UM-8007-01, Issue 1
Battery
drawer
Mounting
hole
Figure 8 on page
13; take up the cable slack
SPX-CABFIN01, SPX-CABFIN04
Advertisement
Table of Contents
