Table of Contents
Advertisement
LTPS-UM-8007-01, Issue 1
I
NSTALLATION
B
Y
B
EFORE
OU
Before beginning these procedures, obtain the following special tools and equipment:
•
One hoist (crane) capable of lifting 2,000 lb (900 kg)
•
Two wire rope slings, 8-foot (2-m) minimum length, each with 2,000 lb. (900 kg) capacity. (If slings of
sufficient length are not available, a spreader bar is required to ensure that the cables pull on the lifting
eyebolts in a vertical direction.)
•
Two connecting links (to attach wire rope slings to the cabinet lifting eyebolts)
•
Rope, for use as tagline; 5/8-inch (40 mm) diameter, approximately 75 feet (19m) long
P
C
LACING THE
For this procedure the following equipment is required:
•
One hoist (crane) capable of lifting 2,000 lb (900 kg)
•
Two wire rope slings, 8-foot (2-m) minimum length, each with 2,000 lb (900 kg) capacity. (If slings of
sufficient length are not available, a spreader bar is required to ensure that the cables pull on the lifting
eyebolts in a vertical direction.)
•
Two connecting links (to attach wire rope slings to the cabinet lifting eyebolts)
•
Rope, 5/8-inch (40 mm) diameter, approximately 75 feet (19m) long (for use as tagline)
Observe the following safety measures when placing the cabinet:
•
Before lifting the cabinet, block off the area. Vehicles should not be parked within 25 feet
(6.4m) of the lifting circumference.
•
Keep bystanders away from work operations at all times.
•
All personnel working with crane equipment should have the proper safety attire as required
by company or local safety standards, including standard safety headgear, eye protection,
and, when required, insulating gloves.
•
Do not operate the crane until all stabilizers are extended and firmly supported. Do not
attempt to retract or extend the stabilizers while a load is suspended.
•
Operators should not suspend loads over people, nor should any person be permitted to
work, stand, or pass under a suspended load.
•
Do not stand on the load or under the load; do not place any part of your body under the load.
•
When raising the crane from the stowed position and while operating the crane, be alert for
overhead obstructions or power lines.
•
Do not exceed the crane capacity.
•
If the cabinet is to be moved while attached to the pallet (such as in a turnkey staging area
or temporary storage location), it may be lifted by a forklift vehicle, provided that the forklift
is rated at 2,000 lb (900 kg) and has a minimum fork length of 30 inches (0.76m).
•
Do not lift the pallet and cabinet from the ends when using a forklift; lift from the sides of the
pallet only.
SPX-CABFIN01, SPX-CABFIN04
EGIN
ABINET ON THE
November 9, 2001
P
AD
Installation
11
Advertisement
Table of Contents
