treesse Muse Operating And Maintenance Manual page 16

Use
EXAMPLE:
access to programming
Setting the duration of
filtering (in the example d3=
3
hours)
confirm duration set
FILTERING
FUNCTION
Setting hours of delay to
start (in the example S4=
FLT
4
hours)
confirm delay set
In this example, if at the
time of programming it is
4 pm, the function - lasting
3 hours
(i.e.,
at 8 am, then again at 8
pm and so on, with a non-
variable frequency of 12
hours between one filtering
and the other.
Filtering is used to filter and sanitise water by sequentially
activating water pumps, blowers (if present) and recirculation
pumps. When active, the display shows the message "FLT"
alternating with the water temperature.
If a user starts a function (e.g., the whirlpool) while the filtering
function is also active, the filtering function is temporarily
interrupted and starts again 15 minutes after the function
tasto
started by the user is turned off.
nascosto
There are 2 filterings per day having a default duration of 2
hours each (duration that can be set by the user), 12 hours
apart from each other (non-variable value).
Change the factory settings (two filterings per day lasting two
hours each) only if necessary.
PROGRAMMING
• Press the "hidden" key
• The display shows the word "dx", where "x" indicates the
• Set the desired duration with + or -
• Press the
• After the key is pressed the new filtering time is stored and
• The display shows the message "Sx", where "x" indicates
• Set the value desire using the + or - keys (valid range:
- will start at 8 pm
• Press the
4 hours
later), then
Once programmed, the function starts after the set delay and
will be repeated every 12 hours for the duration set.
Muse - Maya - Wave
EN
(located below the display, even
if it is not visible it is active)
the + key.
duration in hours of filtering
- default value).
0 (no filtering) to 12h (continuous
key to start the entered value.
the next parameter is set, i.e., after how many hours from
the programming the function must start.
(e.g., S4= the function will start after 4
the hours of delay
hours from the hour in which the programming is being
done).
from 0
(filtering starts immediately after programming)
(filtering will start after 12 hours)
key to start the entered value.
16
minipool
and then, within three seconds,
(e.g., d2 = 2 hours of filtering
(valid values from
filtering);
to 12h
.