Safety Precautions - Toshiba Q7 Installation And Operation Manual

Safety Precautions

Rotating shafts and electrical equipment can be hazardous. Installation, operation, and maintenance
DANGER!
shall be performed by Qualified Personnel only.
Qualified Personnel shall be:
•
•
•
•
Installation of ASD systems should conform to the 2002 National Electrical Code Article 110 (NEC)
(Requirements For Electrical Installations), all regulations of the Occupational Safety and Health
Administration, and any other applicable national, regional, or industry codes and standards.
•
•
•
DO NOT install, operate, perform maintenance, or dispose of this equipment until you have read and
understood all of the product warnings and user directions. Failure to do so may result in equipment
damage, operator injury, or loss of life.
Lock out and tag out all power feeding the enclosure before opening the door of the enclosure.
Q7 ASD Installation and Operation Manual
Familiar with the construction and function of the ASD, the equipment being driven, and the
hazards involved.
Trained and authorized to safely clear faults, ground and tag circuits, energize and de-energize
circuits in accordance with established safety practices.
Trained in the proper care and use of protective equipment in accordance with established safety
practices.
Able to recognize and properly address hazards associated with the application of motor-driven
equipment.
Ensure that the Run functions (F, R, Preset Speed, etc.) of the ASD are off before performing a
Reset. The post-reset settings may allow the ASD to start unexpectedly.
In the event of a power failure, the motor may restart after power is restored.
Retry or Reset settings may allow the motor to start unexpectedly. Warnings to this effect should
be clearly posted near the ASD and motor.
1