Toshiba Q7 Installation And Operation Manual page 49

PS Speed Mode 14
PS Speed Mode 14
PS Speed Mode 15
PWM Carrier Frequency
Ramped PWM
R Delay
Reach Detection
Reach Frequency
Receive Address
Reference Priority Selection
Regen Stall
Release After Run
RES Terminal
RES Delay
Ridethrough Mode
Ridethrough Time
RR Input
RR Speed Freq #1
RR Speed Freq #2
RR Speed Ref #1
RR Speed Ref #2
RR Torque Ref #1
RR Torque Ref #2
RS485 Baud Rate
RS485 Master Output
Q7 ASD Installation and Operation Manual
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
The user-set ASD output frequency that is used to apply the pulsating DC voltage
to the motor.
Enables/Disables the variable PWM frequency.
This setting delays the response of the drive output to any change in the R
terminal input.
Sets the bandwidth of the Reach function if enabled.
This setting establishes a frequency threshold that, when reached or is within the
specified bandwidth, will provide a signal at an output terminal that can close an
appropriately configured output contact.
This setting defines a memory location to be used for received data via a
Multicom option board.
Either Frequency Mode #1 or Frequency Mode #2 may control the output
frequency of the ASD. This parameter determines which of the two will control
the output frequency and the conditions in which control will be switched from
one to the other.
Enables/Disables the Overvoltage Stall and the Overcurrent Stall function
during regeneration only.
This setting sets the time that the brake will hold after the Run command criteria
has been met.
Multifunctional programmable discrete input.
This setting delays the response of the drive output to any change in the RES
terminal input.
This setting determines the motor-control response of the drive in the event of a
momentary power outage. During a Ridethrough, regenerative energy is used to
maintain the control circuitry settings; it is not used to drive the motor.
In the event of a momentary power outage, this parameter determines the length
of the Ridethrough time. During a Ridethrough, regenerative energy is used to
maintain the control circuitry settings; it is not used to drive the motor.
Displays the RR input level.
This parameter sets RR Speed Freq #1 (frequency) and is the frequency that is
associated with the analog input RR Speed Ref #1 (%).
This parameter sets RR Speed Freq #2 (frequency) and is the frequency that is
associated with the binary input RR Speed Ref #2 (%).
This parameter sets RR Speed Ref #1 (%) and is the analog input that is
associated with the frequency/direction setting RR Speed Freq #1 (frequency).
This parameter sets RR Speed Ref #2 (%) and is the binary input that is
associated with the frequency/direction setting RR Speed Freq #2 (frequency).
This parameter sets RR Torque Ref #1 (%) and is the binary input that is
associated with the torque/direction setting RR Speed Freq #1 (frequency).
This parameter sets RR Torque Ref #2 (%) and is the binary input that is
associated with the torque/direction setting RR Speed Freq #2 (frequency).
Sets the information transfer rate for RS485 communications.
In a master/follower configuration, this setting determines the output parameter
of the master ASD that will be used to control the applicable follower ASDs.
RS485 Master Output
43