Toshiba Q7 Installation And Operation Manual page 45

Maximum Voltage #3
Maximum Voltage #3
Maximum Voltage #4
Mode 1/2 Switching Frequency
Motor 150% Run Time Setting
Motor Capacity
Motor Constant 1
Motor Constant 2
Motor Constant 3
Motor Constant 4
Motor Constant 5
Motor Load
Motor Overload Ratio
Motor Poles
Motor Slip Gain
Motor Type
MS Relay (status Anded) with
ST
Multiplying Input Select
Number of Retries
ON Terminal
OUT1 Terminal
OUT1 Off Delay
OUT1 On Delay
OUT2 Terminal
OUT2 Off Delay
Q7 ASD Installation and Operation Manual
This setting determines the maximum value of the output voltage of the drive for
the #3 motor when using a multiple-profile configuration.
This setting determines the maximum value of the output voltage of the drive for
the #4 motor when using a multiple-profile configuration.
This setting determines if Frequency Mode #1 or #2 will control the output
frequency and the conditions in which control will be switched from one to the
other.
This parameter establishes a time that the motor may operate at 150% of its rated
current before tripping.
This setting identifies the wattage rating of the motor.
This reading is the measurement of the stator resistance and is considered a
Motor Constant (unchanging). This value is used in conjunction with other
constants to tune the motor.
This reading is the measurement of the rotor resistance and is considered a
Motor Constant (unchanging). This value is used in conjunction with other
constants to tune the motor.
This reading is used to input the excitation inductance for the motor. This value is
used in conjunction with other constants to tune the motor.
This reading is used to control the load inertia during speed changes.
Acceleration and deceleration overshoot may be reduced by increasing this value.
This reading provides slight increases in the output voltage of the drive at the
high speed range.
Displays the instantaneous motor load.
This value displays the relationship of time to the magnitude of the motor
overload as a ratio. A higher overload means a shorter run-time in this condition.
This setting identifies the number of motor poles.
This setting determines the output torque response sensitivity for a given load
change.
This setting identifies the type of motor being used.
The MS1 AUX relay circuit is normally open; after normal system power is
available, the MS1 AUX relay circuit closes the ST-to-CC connection.
Selecting either of the input methods enables this feature. The selected input is
used as a multiplying modifier of the programmed output frequency.
After a trip has occurred, this parameter sets the number of times that an
automatic system restart is attempted.
Multifunctional programmable discrete input (Multicom expansion card
required).
Multifunctional programmable discrete output.
This setting delays the Off response-time of the OUT1 terminal to an input
change.
This setting delays the On response-time of the OUT1 terminal to an input
command.
Multifunctional programmable discrete output.
This setting delays the Off response-time of the OUT2 terminal to an input
change.
OUT2 Off Delay
39