Toshiba Q7 Installation And Operation Manual page 52

Speed Reference Station
Speed Reference Station
Speed Search Selection
Stall Period
Startup Frequency
ST Delay
ST Terminal
Switch-on-the-fly
Torque Boost #1
Torque Boost #2
Torque Boost #3
Torque Boost #4
Torque Reference Address
Torque Reference Station
Transmit Address
Trip Code
Trip Hold Frequency
Trip Save
TTL Baud Rate
TTL Master Output
TTL Response Time
Type Reset
Undervoltage Stall Level
Undervoltage Time
46
In a multiple-ASD configuration, this setting determines the source of the speed
reference.
Enables/Disables the ability of the drive to start into a spinning motor when the
ST-to-CC connection momentarily opens and is then closed (Break/Make ST) or
after a power interruption (momentary power failure).
This setting allows the user to extend the Overvoltage Stall and the Overcurrent
Stall time settings.
Sets the initial output frequency when a Run command is received.
This setting delays the response of the drive output to any change in the ST
terminal input.
Multifunctional programmable discrete input.
The ability to switch between the Manual and Auto modes while running.
This function is used to increase the low frequency torque for high-inertia loads
by increasing the output voltage at frequencies below ½ of the #1 Base
Frequency.
This function is used to increase the low frequency torque for high-inertia loads
by increasing the output voltage at frequencies below ½ of the #2 Base
Frequency.
This function is used to increase the low frequency torque for high-inertia loads
by increasing the output voltage at frequencies below ½ of the #3 Base
Frequency.
This function is used to increase the low frequency torque for high-inertia loads
by increasing the output voltage at frequencies below ½ of the #4 Base
Frequency.
In a multiple-ASD configuration, this setting determines the memory location of
the torque reference.
In a multiple-ASD configuration, this setting determines the source of the torque
reference.
This setting defines a memory location to be used for transmitted data via a
Multicom option board.
Displays the active trip.
Displays the at-trip frequency or current frequency if no trip is active.
Enables/Disables the Trip Save at Power Down setting. When enabled, this
feature logs the trip event and retains the trip information when the system
powers down so that the trip is active when the power is restored.
Sets the information transfer rate for TTL communications.
In a master/follower configuration, this setting determines the output parameter
of the master ASD that will be used to control the applicable follower ASDs.
This setting determines the TTL response delay time.
This feature resets the system, or when performing fault analysis, allows for a
quick system setup change. Press R/W key (once) after Reset Type selection to
execute selection (the system may take up to 10 seconds to respond).
This setting establishes the low end of the DC bus voltage threshold that, once
exceeded, will cause an Undervoltage Stall.
This parameter sets the time that the undervoltage condition must exist to cause
an Undervoltage Trip.
Undervoltage Time
Q7 ASD Installation and Operation Manual