Toshiba Q7 Installation And Operation Manual page 48

PG Speed Ref #2
PG Speed Ref #2
PID Feedback
Post Compensation Frequency
Preset Speed #1
Preset Speed #2
Preset Speed #3
Preset Speed #4
Preset Speed #5
Preset Speed #6
Preset Speed #7
Preset Speed #8
Preset Speed #9
Preset Speed #10
Preset Speed #11
Preset Speed #12
Preset Speed #13
Preset Speed #14
Preset Speed #15
Preset Speed Mode Control
Proportional Gain
PS Speed Mode 1
PS Speed Mode 2
PS Speed Mode 3
PS Speed Mode 4
PS Speed Mode 5
PS Speed Mode 6
PS Speed Mode 7
PS Speed Mode 8
PS Speed Mode 9
PS Speed Mode 10
PS Speed Mode 11
PS Speed Mode 12
PS Speed Mode 13
42
This parameter sets PG Speed Ref #2 (%) and is the pulse count that is
associated with the frequency/direction setting PG Speed Freq #2 (frequency).
Displays the instantaneous PID feedback value.
The output frequency of the ASD after the application of the waveform
adjustment compensation due to changes in the input voltage.
Values that fall within the
Frequency range may be programmed into the drive and output as a Preset
Speed. This parameter assigns an output frequency to the binary number input
0001.
Same as Preset Speed #1 (binary number = 0010).
Same as Preset Speed #1 (binary number = 0011).
Same as Preset Speed #1 (binary number = 0100).
Same as Preset Speed #1 (binary number = 0101).
Same as Preset Speed #1 (binary number = 0110).
Same as Preset Speed #1 (binary number = 0111).
Same as Preset Speed #1 (binary number = 1000).
Same as Preset Speed #1 (binary number = 1001).
Same as Preset Speed #1 (binary number = 1010).
Same as Preset Speed #1 (binary number = 1011).
Same as Preset Speed #1 (binary number = 1100).
Same as Preset Speed #1 (binary number = 1101).
Same as Preset Speed #1 (binary number = 1110).
Same as Preset Speed #1 (binary number = 1111).
Enables/Disables the use of the Preset Speed Mode control. The Preset Speed
Mode control setting determines if the speed only is used (disabled) or if
(enabled) the Torque, Speed, Accel/Decel, and Direction settings will be used
while running a given preset speed.
When using PID feedback to control the ASD output, this function is used to
control the output by applying a multiplier to the error.
When Enabled, the Preset Speed Mode Control
#1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Same as PS Speed Mode 1.
Lower Limit Frequency
is in effect for Preset Speed
Q7 ASD Installation and Operation Manual
PS Speed Mode 13
and the Upper Limit