Physical Connections And Configuration Settings; Network, Keyboard, Display; Power - Emerson PACEdge User Manual

PACEdge User Manual
GFK-3178B
Section 3:
Configuration Settings
3.1.1

Network, Keyboard, Display

PACEdge is designed to primarily operate on a headless compute device using web interfaces,
however, if desired, a monitor and keyboard can be attached.
To use web interfaces, the user must know the IP address assigned to the Ethernet port. If using a
keyboard and local display, the IP address assignment can be easily checked using Linux
commands. Otherwise following options are available:
RXi2-LP: LAN port
next to the USB port
1. Follow the Ethernet Port and IP address guidance above.
2.
3.1.2

Power

1. Connect 24V +/-25% power to the power connector and power up the unit (Figure 3).
2. The corresponding plug must be a Phoenix Contact "1748367" or equivalent.
RXi2-BP can be powered with a DC power supply with 24V (+-25%) and at least delivering 1.8 A.
Figure 3: 24 V DC-IN
Quick Start Guide
Physical Connections and
PACEdge Factory Installation
Static IP on 1 st Ethernet port:
192.168.3.100
RXi2-BP: ETH0
Attach Ethernet cable to an appropriate Ethernet port.
Optionally, attach a USB keyboard to any of the USB ports.
Optionally, attach a display to the DP++ port.
Note: DisplayPort (DP++) connection is well suited for conversion to HDMI and VGA.
(Conversion adapters are not included).
DHCP assigned IP on any Ethernet
port
Signal Name
Power + (24V DC)
Power - (24V DC)
FGND
Section 3
port
Pin (left to right)
1
2
3
Nov 2020
4