Table of Contents
Advertisement
6. Prior to installing the faceplate, be sure
the rubber seal is properly installed on the
back of the faceplate.
7. Install the faceplate by firmly pressing it
into place over the base unit housing.
Note: Press the plate in at a slight angle,
leading with the bottom edge.
8. After configuration is completed align and
engage the top two snaps. Then, align
and install the front lens to the faceplate
by inserting top snap first, followed by
the bottom snap. Left and right snaps are
alignment only.
8
Advertisement
Table of Contents
Need help?
Do you have a question about the setralite and is the answer not in the manual?