Setra Systems setralite Installation & Operating Manual page 12

9. If mounting to wall install a screw in the
wall via drywall anchor or screwing into
a supportive structure leaving the screw
protruding approximately 1/8" (3mm).
Place quickmount onto screw, then
tighten screw until firmly tightened.
Note: Unit can also be placed on a flat
surface.
10. Configure Setra Lite per section 8.0
11. After configuration is completed, align
and install the front lens to the faceplate
by inserting top snap first, followed by
the bottom snap. Left and right snaps are
alignment only.
12