A1.4 Led Modes And Functions - Telular TELGUARD DIGITAL TG-1 Installation And Operating Instructions Manual

A1.4 LED M
LED Function Table – Normal Operating Mode (J10 = OPEN
LED Symbol
LED 6
LED 1
Registration
LED 2
STC
LED 3
MODE
LED 4
Acknowledgement
LED 5
LED Function Table – View RSSI Mode (J10 = SHORTED
RSSI Value
NO SVC
Note: LED 1 = on indicates more than one cellular tower.
56034002 1/9/2006
F
ODES AND UNCTIONS
Color Duty Cycle
RED Solid On
Green Solid On
Off
Flashing
OFF
RED
1 Flash*
2 Flashes*
3 Flashes*
4 Flashes*
5 Flashes*
6 Flashes*
Off
Yellow
On
Fast Flash
Red Solid ON
OFF
Flashing
Green OFF
On
Short Flash (1 sec)
Long Flash (2 sec)
LED's Lighted
LED 5 = slow flash, LED 4-2 = off
1 LED 5 = on, LED 4-2 = off
1½ LED 5 = on, LED 4 = slow flash
LED 3-2 = off
2 LED 5-4 = on, LED 3-2 = off
2½ LED 5-4 = on, LED 3 = slow flash
LED 2 = off
3 LED 5-3 = on, LED 2 = off
3½ LED 5-3 = on, LED 2 = slow flash
4 LED 5-2 = on
14
Indication
AC power connected to unit
Unit is registered with the message center and enabled
Unit not registered with message center (and disabled)
Unit is registered but disabled
ALL OK
System Trouble Condition – Low/Missing AC Power
System Trouble Condition – Low/Missing Battery Condition
AND/OR Battery Charger Failure
Not used
System Trouble Condition – NSC
System Trouble Condition – RFC
System Trouble Condition – DTF
Mode 2, Cell Priority (normal operation)
Mode 1, N/A for TG-1
C/C off-hook to transmit signals over cellular.
Telguard TG-1 waiting for acknowledgement from
Communication Center
Idle state
When flashing with LED 1 unit has failed registration due to the
programming of the panel, CALL TECH SUPPORT
TG-1 initialized
TG-1 initializing & registering with cellular network or
Transmitting Alarm Data
Radio receiving message
Radio sending message
RF dBm
n/a
≤ -111 dBm
≥ -110 dBm
≥ -100 dBm
≥ -90 dBm (Minimum signal
strength required)
≥ -80 dBm
≥ -70 dBm
≥ -60 dBm
)
)
© 2006 Telular Corporation